Wiring An In Line Switch. After all of the wires are secure, the switches can be secured back into the. Web connecting the new switch.
Useful Information for Inline light switches from www.lampsandlights.co.uk
In the photo above, the green arrow points to the line hot wire connected. If you run into short wires, there’s an easy fix. First, tighten the bare copper or green wire to the green.
First, Tighten The Bare Copper Or Green Wire To The Green.
Make sure that the wires are snug in their slots without being pinched. If you run into short wires, there’s an easy fix. Web place the other side of the inline switch on top of the one with the wires.
Web Leave The Wires Long Enough To Protrude At Least 3 In.
Once done, free the terminal wires, using pliers if. This is the wire that provides the 120 volts of power to your switch from the power. After all of the wires are secure, the switches can be secured back into the.
Web Connecting The New Switch.
Loosen the screws holding the terminal wires in place. Web it’s a case of take your time to make a neat wiring job. Install the switch covers, turn on the power, and then check the switches.
Disconnect The Terminal And Ground Wires.
Please do not over tighten the live terminal as this may break the rivet holding it in place. In the photo above, the green arrow points to the line hot wire connected. Bend the ends of the wire into a half moon shape to go around the screws.
Web This Is Installed In The Wire Hole Labelled With The Ground Symbol (Shown Below).
